I’ve already build this circuit once but I had an idea for a different graphic. I have been playing with the Tayda UV printing and wanted to give it another go. This one is not perfect as the whites did not come out the way I wanted. I will keep trying. I am going to put up a run of a few of these. We will see how it goes. I am very slow at selling pedals though.
Controls
From the spec sheet:
- GAIN: Controls the overall input gain of unit
- HI-CUT: Provides a post OD high frequency cut ideal for amp tuning
- VOLUME: Controls the overall volume of the unit
Switches
- BRITE: This circuit provides tw - levels of pre OD high frequency boost and an off setting. The degree of boost decreases
as the GAIN control is increased.
- UP: maximum boost. Adds extreme top end clarity and should be set to get best clean-up performance when using humbucker pickups.
- MIDDLE: OFF, Flat Band Response
- DOWN: Moderate boost ideal for adding sparkle to your tone.
- VOICE: Provides tw - distinct voices for the pedal post OD.
- UP: Traditional Voice
- DOWN: Modern British Voice
- PRESENCE: Provides three levels of post OD high frequency response. Ideal for matching the unit to your amp s top end
response.
- UP: maximum boost. Adds top end bite. Best used with dark amps or when going int - a flat band power amp
- MIDDLE: Flat frequency response
- DOWN: Darkest setting used best with a bright amp
- CAB: Provides three modes ideal for matching the unit to your amp s low end response.
- UP: 4x12 Adds extended low end boost
- MIDDLE: OFF, Flat Band Response
- DOWN: 2x12 Adds moderate low end boost
Build Gallery
